bgzip – Block compression/decompression utility
bgzip [-cdfhikrt] [-b virtualOffset] [-I index_name] [-l compression_level] [-s size] [-@ threads] [file]
Bgzip compresses files in a similar manner to, and compatible with, gzip(1). The file is compressed into a series of small (less than 64K) 'BGZF' blocks. This allows indexes to be built against the compressed file and used to retrieve portions of the data without having to decompress the entire file.
If no files are specified on the command line, bgzip will compress (or decompress if the -d option is used) standard input to standard output. If a file is specified, it will be compressed (or decompressed with -d). If the -c option is used, the result will be written to standard output, otherwise when compressing bgzip will write to a new file with a .gz suffix and remove the original. When decompressing the input file must have a .gz suffix, which will be removed to make the output name. Again after decompression completes the input file will be removed.
Decompress to standard output from virtual file position (0-based uncompressed offset). Implies -c and -d.
Write to standard output, keep original files unchanged.
Overwrite files without asking, or decompress files that don't have a known compression filename extension (e.g., .gz) without asking. Use --force twice to do both without asking.
Try to use an existing index to create a compressed file with matching block offsets. Note that this assumes that the same compression library and level are in use as when making the original file. Don't use it unless you know what you're doing.
Displays a help message.
Create a BGZF index while compressing. Unless the -I option is used, this will have the name of the compressed file with .gzi appended to it.
Index file name.
Do not delete input file during operation.
Compression level to use when compressing. From 0 to 9, or -1 for the default level set by the compression library. [-1]
Rebuild the index on an existing compressed file.
Decompress INT bytes (uncompressed size) to standard output. Implies -c.
Test the intregrity of the compressed file.
Number of threads to use .
It makes use of a gzip feature which allows compressed files to be concatenated. The input data is divided into blocks which are no larger than 64 kilobytes both before and after compression (including compression headers). Each block is compressed into a gzip file. The gzip header includes an extra sub-field with identifier 'BC' and the length of the compressed block, including all headers.
All values are stored as little-endian 64-bit unsigned integers.
The file contents are:
uint64_t number_entriesfollowed by number_entries pairs of:
uint64_t compressed_offset uint64_t uncompressed_offset
# Compress stdin to stdout bgzip < /usr/share/dict/words > /tmp/words.gz
# Make a .gzi index bgzip -r /tmp/words.gz
# Extract part of the data using the index bgzip -b 367635 -s 4 /tmp/words.gz
# Uncompress the whole file, removing the compressed copy bgzip -d /tmp/words.gz
The BGZF library was originally implemented by Bob Handsaker and modified by Heng Li for remote file access and in-memory caching.
Copyright © 2021 Genome Research Limited (reg no. 2742969) is a charity registered in England with number 1021457. Terms and conditions.